LASER CLASS 730i/720i/710 Chapter 5: Appendix
5-85
b-6) Removing the kit
When removing the kit, perform the steps in b-4) Attaching to the main unit in reverse
order. Be sure to remove the kit only after turning the power off.
3.8.3 Technical information
a) Specifications
Interface 10Base-T, 100Base-TX
CPU RISC CPU (100 MHz)
Protocol IPX/SPX, PServer, NDS PServer, NDPS, LPD, Port9100, NetBIOS
IPP, PAP (Apple Talk Printer Access Protocol)
3.8.4 Maintenance and service
a) Troubleshooting
The fax does not recognize the Network Kit III even when it is attached
properly.
Solutions: (1) Check that the kit is securely connected.
(2) Replace the kit.
(3) Replace the SCNT board.
To Next Page
Loading...
