LASER CLASS 730i/720i/710 Chapter 4: Maintenance and Service
4-78
6.6 AGING Test
The AGING test is selected by pressing the numeric button 5 from the test mode menu. In this
test, the contact sensor LED is lit, and the document read motor driven in fine mode. Also, the
printer will fine print a endurance pattern. The AGING test will end after the output of the
printer is halted by pressing the Stop button.
6.7 Faculty Tests
The faculty tests are selected by pressing the numeric button 6 from the test mode menu. These
tests test the following faculties of this fax.
Test type Overview
Sensor tests Test whether the sensors are operating correctly.
Operation panel test Tests whether the button switches on the control panel are
operating correctly.
Stamp test Tests whether the stamp function is operating correctly.
a) Sensor tests
The sensor test is selected by pressing the numeric button 3 from the faculty test menu. In
this test, you can check the status of each sensor of this fax in items 1 to 4 on the display.
You can also check if sensors that use actuators and microswitches are operating correctly
by moving the actuator or microswitch.
To Next Page
Loading...
