LASER CLASS 730i/720i/710 Chapter 4: Maintenance and Service
4-14
“OUTPUT TRAY FULL”
Cause: The output tray is full of paper.
Solution: Pick up the printed pages on the tray.
“PASSWORD POLL REJECT”
Cause: You set up a polling box for polling sending with an ITU-T password, but the
other party’s fax unit does not support use of an ITU-T password for polling
receiving.
Solution: Transmit without an ITU-T password.
“PASSWORD TX REJECT”
Cause: You attempted to send a document with an ITU-T password, but the other
party’s fax unit does not support use of an ITU-T password for receiving.
Solution: Transmit without an ITU-T password.
“PRT ALT. PAPER SIZE? YES=(*) NO=(#)”
Cause: The size of the available recording paper does not match the size of the
document waiting to be printed.
Solution: If you do not mind printing on a different paper size, press * button.
If you want to print the correct paper size, press Stop button and install the
correct size paper.
“REC. PAPER JAM” (#0009)
Cause: Recording paper jam.
This is displayed when the sensor detects a paper jam.
Solution: Recover paper jam.
“RECEIVED IN MAILBOX”
Cause: A confidential document has arrived in a mailbox of the fax unit, and the
message will remain displayed until you print the document.
Solution: Output the document in the confidential mailbox.
“RECEIVED IN MEMORY”
Cause: (1) The fax unit has run out of recording paper.
(2) The toner supply of the toner cartridge is exhausted.
(3) The output tray is full of paper.
Solution: (1) Supply paper to the paper cassettes.
(2) Change the toner cartridge.
(3) Pick up the printed pages on the tray.
To Next Page
Loading...
