Chapter 10 Maintenance 106
Confirming the nozzle check pattern
This section describes how to confirm the nozzle check pattern and print head position pattern.
NOTE
• If the ink level is low, the nozzle check pattern is not printed correctly. If the ink level is low, replace the
relevant ink tank. (See page 98.)
z If the lines are broken, or white lines are present in pattern :
1. Clean the print head. (See page 107.)
z If the pattern is not uniform:
1. Align the print head. (See page 108.)
z If white vertical lines are obvious in pattern :
1. Align the print head. (See page 108.)
1
2
3
Broken lines White lines
Not uniform Uniform
White lines
To Next Page
Loading...
