123
Troubleshooting
Memory card is full. z Insert a new memory card (Basic
Guide p. 7).
z If required, download the images
to a computer and erase them
from the memory card to make
space.
Memory card is not
formatted correctly.
z Format the memory card (p. 33).
z If reformatting does not work, the
memory card logic circuits may be
damaged. Consult the nearest
Canon Customer Support Help
Desk.
SD memory card or SDHC
memory card is write
protected.
z Slide the write protect tab upward
(p. 136).
Image Seen in Viewfinder vs. Recorded Image
Usually the recorded image
contains more of the scene
than is seen in the viewfinder.
z
Confirm the actual image size with the
LCD monitor. Use the LCD monitor
when taking close-up shots (p. 12).
Image is blurred or out of focus.
AF-assist Beam is set to
[Off].
z In dark places where it is difficult for
the camera to focus, the AF-assist
Beam will emit to assist focusing. As
the AF-assist Beam will not function
when turned off, set it [On] to
activate it (p. 27). Take care not to
obstruct the AF-assist Beam with
your hand when used.
The camera moves when
the shutter button is
pressed.
z
Set the IS Mode to any setting other
than [Off] (p. 35).
z
Setting the self-timer to (2
seconds) delays the shutter release
for 2 seconds after the shutter
button is pressed and allows the
camera to stop shaking, thus
preventing a blurred image (
Basic
Guide
p. 17).
Even better results can be obtained
by placing the camera on a stable
surface or by using a tripod to shoot.
To Next Page
Loading...
Need help?
General
