80
3
Aim the camera so that the original color
appears at the center of the LCD monitor
and press the button.
z Only one color can be specified.
z You can use the or button to or the control dial
specify the range of colors that are swapped.
4
Aim the camera so that the desired color
appears at the center of the LCD monitor
and press the button.
z Only one color can be specified.
5
Press to complete the setting, then
shoot.
z The default setting for color swap mode will change green
into white.
z You may not obtain the expected results if you use the flash.
z The colors specified in the color swap mode are retained
even if the camera’s power is turned off.
–5: Only takes the color that you want to swap.
+5: Also takes colors close to the one that you want to swap.
To Next Page
Loading...
