– 29 –
7
Maintenance
• Check body panels and covers for
crack, deformation, and loose or
missing fasteners.
• Check cutting blades for cracks or
damage.
• Check blade mounting carriage
bolts for cracks or damage.
• Check cutting blade shield for
cracks or damage.
• Check skirt on cutting blade shield.
• Check belt tension.
• Check belt for damage or wear.
• Move rotary clutch lever to engage
rotary brake.
• Check greasing points.
• Operate head lamp switch to check
if it works.
• Check head lamp for damage or
water.
There shall not be cracks,
deformation, loose or
missing fasteners.
Blades shall be free of
cracks or damage.
Carriage bolts shall be
free of cracks, damage or
excessive wear.
Shield shall be free of
cracks or damage.
skirt shall be free of
cracks or damage, and
shall not be missing.
Shall be properly adjust-
ed.
Shall be free of damage
or excessive wear.
Rotary shall stop imme-
diately.
Greasing points shall be
sufficiently greased.
Head lamp shall light up.
Head lamp shall be free
of damage and there shall
not be water in it.
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
Inspecting/Changing:
Page 46
Inspecting/Changing:
Page 46
Adjusting: Page 43
Adjusting: Page 43
Adjusting: Page 43
Greasing: Page 36
Timing
Pre-op
Yearly
Monthly
Content RemarksItem
Body
Body Panels
Cutting System
Cutting SystemElectrical System
Head Lamp
To Next Page
Loading...
