EasyManua.ls Logo

CanyCom CM1802 - Page 59

Default Icon
63 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
Troubleshooting
– 53
Area
Power
transmission
system
Engine
Brake system
Steering
system
Chassis
Lighting
system
Malfunction
White smoke or blue smoke
comes out. (Abnormal exhaust)
Machine does not move when
drive lever is moved forward or
backward.
The unit moves even when
drive lever is in neutral position.
Not effective
Excessive play of brake pedal.
Heavy steering
Cannot drive straight.
Abnormal vibration of the
chassis
Head lamp failure
Possible cause
An excessive amount of
engine oil is put in.
Improper fuel
Worn cylinder or piston ring
Insufficient HST oil
Parking brake is applied.
Drive lever linkage is not cor-
rectly adjusted.
Worn out brake lining
Oil enters into brake drum.
Water soaks inside of drum.
Worn out tire
Incorrect adjustment
Incorrect tire air pressure
Insufficient greasing of king
pin
Malfunction inside steering
gearbox
Incorrect tie-rod adjustment
Incorrect tire air pressure
adjustment
Loose tire fixing bolt
Breakage of wheel bearing
Crack of tire
Improper wiring
Bulb is disconnected.
Blown fuse
Corrective action
After checking adjust oil
level.
( Page 32)
Change fuel.
Check and repair.
(Consult dealer.)
Fill. ( Page 34)
Release parking brake lock
lever. ( Page 20)
Adjust. (Consult dealer.)
Replace lining
(Ask dealer to do the job.)
Replace oil seal.
(Ask dealer to do the job.)
Brake a few times to dry water
inside of drum.
Replace tire.
Adjust. ( Page 44)
Adjust. (
Page 44)
Lubricate. ( Page 35)
Repair.
(Ask dealer to do the job.)
Adjust.
Adjust tire air pressure.
(
Page 44)
Tighten.
Replace.
(Ask dealer to do the job.)
Replace.
Connect properly.
Replace.
Replace.

Related product manuals