Cardinal 200

8200-M035-O1 Rev C  200 Installation & Technical
36
SETUP AND CALIBRATION, CONT.
tyPE= (Continuous Output Format)
Press the TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER key again to save it. Otherwise, use the ASTERISK/UP ARROW key to
toggle to a new setting and then press the TARE/ENTER key to save it. Allowable values are:
0 = SMA
1 = SB-400
2 = SB-200
3 = Rice Lake IQ355
4 = AnDFV
5 = WI110
6 = Number Only
7 = Toledo Long/Short
8 = SB500 with Traffic Light
9 = Ranger 5000 Format A
10 = GEDGE 1650 Format 4
SMA – (Type = 0)
If SMA is selected, the data will be transmitted in the following format:
<lf><s><r><n><m><f><xxxxxx.xxx><uuu><cr>
Where:
lf =
Line Feed
s =
Flags
Z= center of Zero, O = Overcap, E = zero Error,
e = weight not currently being displayed
r =
Range
1, 2, 3, ...
n =
Mode
G = Gross, T = Tare, N = Net
m =
Motion
M = Motion, " "(blank) = no motion
f =
Custom
Custom flag
xxxxxx.xxx =
Weight
Six digits with decimal point
uuu =
Units
ton, lb , l/o, oz , t , kg , g
cr =
Carriage Return
(hex 0D)
SB-400 – (Type = 1)
If SB-400

or Computer is selected, the data will be transmitted in the following format:
<s><xxxxxx><d><uu><m><cc><cr>
Where:
s =
Sign
"-" = negative, " " (blank) = positive
xxxxxx.xxx =
Weight
Six digits
d =
Decimal point
Added to string if enabled in setup
uu =
Units
tn, lb, l/o, oz, t, kg, g
m =
Mode
G = Gross, N = Net
cc =
Weight Status
OC = overcap
CZ = center of zero
MO = motion
ee = weight not currently being displayed
cr =
Carriage Return
(hex 0D)

The SB-80, SB-300 (multiple displays not supported) and WinVRS use the SB-400 format.