8200-M035-O1 Rev C 200 Installation & Technical
SETUP AND CALIBRATION, CONT.
SB500 (with Traffic Light) – (Type = 8)
If SB500 (with Traffic Light) is selected, the data will be transmitted in the following format:
%NDDDDDDDDDT<CR>
Where:
N = Panel number for a daisy chain configuration
D = Byte of data to display at respective location on the scoreboard
T = Control character for the traffic light. Valid characters for T are:
G = Turn on Green light
R = Turn on Red light
" "(space) = no lights on
<CR> = Carriage Return
Ranger 5000 Format A – (Type = 9)
In setup, after selecting type 9 for the Ranger 5000 Format A:
At the StArtb prompt, enter the decimal value for the start character.
Valid entry is 0 to 126.
At the Endb 1 prompt, enter the decimal value for the first end character.
Valid entry is 0 to 126.
At the Endb 2 prompt, enter the decimal value for the second end character.
Valid entry is 0 to 126.
If the above items are ‘0’ then the character will not be included in the data stream.
If Ranger 5000 Format A is selected, the data will be transmitted in the following format:
<StArtb>Sign WeightA(7) Status
Where:
Sign = The sign of the weight (‘ ‘ for positive, ‘-‘ for negative)
WeightA = A seven character string containing the current weight including the decimal
point. If there is no decimal point, then the first character is a space.
Leading zero blanking applies.
Status = Provides information on the weight reading. The characters G/N/U/O/M/E
represent Gross/Net/Underload/Overload/Motion/Error respectively.
To Next Page
Loading...
