kVent – rel 3.1 – 22/06/2018
50
comfort-economy), not just the set point and fans speed but also a dedicate PID parameters for the
free cooling and the relative coil (heating/cooling if it is present).
• Adding a function to check the differential of pressure between the supply and exhaust fan,
modulating the exhaust or return fan to keep the pressure constant.
• in addition, units are equipped with two modulating dampers in fresh air and mixed air .we want two
analog outputs for controlling dampers, that a fresh damper can be set to constant value.
• added all the masks to set up the PID parameters for each coils in base of the working mode.
• added the fresh modulating damper
• Condensing Unit Management
• Add the RU language
• Add the CZ language
• Added the c.filed web pages for commissioning
Manual
• Add pGDX user interfaces
2.1.2
22-06-2018
3.1
01-06-2018
• Fix a wrong behaviour on the fan if set up the water coils on pre/re-heaters, even if the unit was in
oFF, the fans started
Changed
• changed the unit of measure from s, to min on the time setting for the pump on the heating coils
during the off time
• Disabled the Antifreeze water probe on the heating coil during the cooling mode
Improved
• Added the possibility to define the frame on the fieldbus port
Manual
To Next Page
Loading...
