kVent – rel 3.1 – 22/06/2018
48
8. NEW FUNCTIONALITIES FROM VER. 2.1.0
8.1 Modulating Fresh air damper
From the release 2.1.0, there is the possibilitiy to setup a Fresh
dumer modulating that can work on a fix position or modulate
according with the mixing damper if present.
The parameters that permit those settings are under the menu
Settings, H025 to enable the fix position and H026 to setup the
percentage of the fix position opening.
8.2 Additional device signals to send a
feedback to external devices
From the release 2.1.0, there is the possibility to send through
analoge outputs the request for the main coils to external devices.
The enabling is manage under the menu Settings parameter H027.
8.3 Advanced PID settings for the
working modes
From the release 2.1.0, there is the possibility to setup a different
PID values for each devices in base of the working mode set .The
enabling is manage under the menu Settings parameter H028.
8.4 HEPA filters management
From the release 2.1.0, there is the possibility to setup like supply
filters,up to two HEPA filters devices that can work in base of their
differential pressure sensor, and you can regulate the fans speed
according with their pressure value.
The parameters to setup them are on the control type for the Fan,
setting the “HEPA”regulation.
8.5 Regulation CAV and VAV in supply
only units
From the release 2.1.0, we added the possibility to set up the VAV
or CAV regulation also in case the unit is setup to works with just
the supply fan, without the return.
8.6 FieldBus frame configuration
From the release 2.1.2, we added the possibility to set up the
protocol frame about the Modbus Master, the parameters to define
it are Ha91 to Ha93.
To Next Page
Loading...
Need help?
General
