CAS CBX - Weighing; MENU ITEM SELECTION

21
2 MEMU ITEM SELECTION
2.1 Introduction
The CBX-W and CBW-K series balance has many functions that can be selected to
meet the requirements of the user. Menu Item selection is used to program these
functions.
The symbol is displayed during Menu Item selection.
Once the menu items have been set based on the installation environment and
weighing purpose, it is not necessary to select the menu items each time the balance is
used. Once the contents of the menu are set, they are stored even if the balance is
turned OFF or if the power is disconnected.
2.2 Procedure of Menu Item Selection
The menu of the CBX-W / CBW-K balance consists of four levels.
1) Press the
key to cycle through the items within a menu level.
( in the table below)
2) Press the
key to choose the current item or move to the
next menu level.
( in the table below)
3) Press the
key to move back one menu level.
4) Press and hold the key to return to the mass display.
This instruction manual identifies each menu item by a number. For
example,
, “Anti-Vibration mode” is identified as [25].
Refer to Section 2.3 "Menu Map" or the attached operation explanatory sheet.