3.2.4 Windows® Direct Function
Note: For Windows®95 Version 4.00.950B, see page 69 “Compatibility Notification Regarding
Linking of “Windows® Direct” Function with Windows®95 Version 4.00.950B.”
The CBX-K and CBW-K series balance can transfer data directly to a personal computer running
Lotus 1-2-3, Excel, or other applications of Windows®*.
3.2.4.1 Preparation (Installation)
Install according to the procedure described below.
1) Supply power to the balance and set the condition for communication as follows.
Menu [74] [77] [81] [89] [92]
Menu [97] [98]
2) Keep pressing the
key and complete selection of the balance menu.
3) Disconnect the power to the personal computer and balance.
4) Connect the personal computer to the balance with the RS-232C cable.
5) Turn ON the power to the personal computer only and start Windows®*.
6) Click "Start", choose "Settings" and "Control Panel" then select "Accessibility Options."
7) Confirm that there are no check marks for any items on tabs including "General."
8) Put a check mark at "Support Serialkey device" in the "General" tag. This is the only check mark
on all the tabs.
9) Open "Settings."
Select the serial port corresponding to the RS-232C port of your personal computer. (Serial port:
any one of COM1 to 4. Mostly, COM1)
11) Select a "Baud rate" of 300.
12) Click "OK."
13) Click "Apply."
14) Click "Start", point to "Shut Down" then click "Restart the computer?".
15) After Windows®* has completely started, turn on the power supply to the balance.
It is not necessary to perform the Windows®* control panel setting operation every time.
To Next Page
Loading...
