7. Set-up
■ Set-up
- Overview
It means the setting works to ensure the indicator to be operated under the optimal conditions by
setting F-FUNCTION properly to the operating devices and surrounding environment.
- How to enter Set-up
“TEST” is displayed when the power is turned on while any key is being pressed.
At this time, press Key to display ST.CAL on the main display.
At this state, press Key to display 01-XX.
EX) While the power is turned off;
① Press "3" Key and turn on the power for “TEST___”
② Press "3" Key for “SET. CAL”
③ Press “CLEAR” Key for “F01-XX”
“Χ” is a random number.
- How to change the unique number for F-FUNCTION
To change the unique number for F-Function, the unique number increases whenever
Key is pressed once.
It increases to 01-53 and then returns to 01.
Whenever Key is pressed, the number increases in 0 -> 9.
Whenever key is pressed, it moves to the left.
Press Key to call the function after the number is assigned to the
function.
Sequential increase in 01-53 if no number is assigned
Press Key to store the currently displayed value and press once again to move to ST. CAL.