CAS CI-1580A - Front Panel Description and Operation; Indicator Display Overview; Understanding Status Indicators

9
■ Key Operations
Key
Descriptions
It is used to set the weight display to „0‟ within a range of maximum weight
(CAPA) defined by the user.
(However, it is operated within the input range by the user to „Equipment Set‟ „08‟
(Set for Zero Range).
It is used to set the tare to „0‟ after a container is put on the weighing tray.
(However, it is operated within the input range by the user to „Equipment Set‟ „09‟
(Set for Tare Range)
It is used for the input of low limit (SP1) and high limit (SP2).
It is used to enter the set value.
■ Special Key Operations
Key
Descriptions
① It is used to increase the numeric value.
② It is used to finish the setting under the SET, CAL status.
① It is used to move the position of a numeric value.
② It is used to move to TEST MODE under the SET, CAL status.
① It is used to increase the unique number (F XX) in „Equipment Set‟.
② When it is pressed under the „SET, CAL‟ status, it moves to „Equipment Set‟
(SET UP).
① It is used to enter (save) the set value by the user in the „Weight Calibration‟
function.
② When it is pressed under the „SET, CAL‟ status, it moves to „Weight Calibration‟
(Calibration).