- How to enter after assigning F-Function
After assigning F-Function using & Key, you may enter the
appropriate F-Function using Key.
1. Whenever Key is pressed, the number increases in 0~9 on the position.
2. Press Key to change the number in 0~9.
3. Press Key again to increase the number in 0~9.
4. Press Key to enter the assigned F-Function.
EX) Assign F53 and then enter it:
1. On the screen for F01-01
2. When the number 1 is blinking, press Key to make the number 3.
3. Press Key to move the number on the position and then the number 0 is blinking.
4. Press Key again to make the number 5.
5. Press Key again to enter the Function immediately.
※ Caution: Be aware that the value for the Function is stored when Key is pressed.
- How to change the setting of F-Function
After entering a value to change the setting of F-Function, press Key to
store it in the internal memory and finish the change.
If Key is not pressed only after the desired value is entered, the value is not
stored.
※ The value can be stored in the internal memory when you press
Key after the value is changed to your desired set value.
To Next Page
Loading...
