Zero Tracking Adjustment Range Setting
The automatic zero calibration if it does not exceed a
certain range of divisions within a certain time if there is
any subtle change in the weight for some reason
(environment, temperature, wind, dust, etc.)
Ex) F04 is set to “3” when the maximum display division is set to 120.00Kg and a division to 0.05Kg;
※ This function prevents the indicator from any impact from the accumulated dusts or dirt where you might have
a lot of dusts or dirt in the environment during the use.
Auto – Zero Range Setting
A function to return the display value to “0” immediately
once the weight is displayed and stabilized under the
set value.
* The automatic zeroing can be done (before the weighing is done again) if there is any remaining
under the set value with no use of „ZERO‟ Key once this function is set.
* Ex) If the maximum display weight is set to 120.00Kg, a division to 0.02Kg and F05 to 30 in the
indicator, the display value becomes “0.00Kg” as the zeroing is immediately operated once
(STEADY LAMP ON) is carried while the remaining amount exists up to ±(0.02~0.30Kg).
More vibration
↑
Less vibration
More Sensitive
Less Sensitive
* This function should be used after the adjustment for the set value depending on the environment
(surrounding vibration).
* Decrease the set value for the quicker response speed in the indicator
ZERO, TARE Key Operation Mode
“ZERO” Key can be operated only if the weight is stabilized.
“ZERO” Key can be operated even if there is any change in the
weight.
If there is weight change within 250g within 0.75 SEC,
the indicator automatically displays 0.
The changed value is shown if there
was any greater change than 250g
within 0.75SEC
To Next Page
Loading...
