CAS CI-1580A - Command Mode: Writing Data (Tare, Zero, Hold)

43
PC→
Indicator
(ASCII)
( HEX )
Command to change
the “Serial” memorized
inside
Remark
STX(1) ID(2) Command(4) S/N(6) ETX(1)
Indicator
response
(ASCII)
( HEX )
PC→
Indicator
(ASCII)
( HEX )
Command to change
the “Part Number”
to the DATA that is now
being transmitted
Remark
STX(1) ID(2) Command(4) P/N(2) ETX(1)
Indicator
response
(ASCII)
( HEX )
PC→
Indicator
(ASCII)
(HEX )
Command to change
the “CODE”
to the DATA
that is now being
transmitted
Remark
STX(1) ID(2) Command(4) C/N(6) ETX(1)
Indicator
response
(ASCII)
( HEX )
PC→
Indicator
(ASCII)
( HEX )
Command to set
the “Hold”
Indicator
response
(ASCII)
( HEX )