CAS CL7200 series - Scanner Config (Menu Code 1464); Label Format Key Table (Menu Code 1470)

115
2.11.6.4 Scanner Config (Menu code 1464)
( MENU → 4. Store Data Table → 6. Scanner → 4. Scanner Config )
1. The way to set up Scan Form
Enter defined 12-digit number or letter that scanner
can recognize.
Assigned representative characters are written below.
-“X” character : It must be the number of same digit length as “Mapping Code”, that you entered
above, has.
-“W” character : It represents weight date.
Any other symbol than “X”, “W” is ignored when scanning.
Example 1) Scan Form : [ XXXXXXXWWWWW ]
- From 1 to 7 digits“XXXXXXX”calls PLU comparing with Mapping Code entered above 4).
- From 8 to 12 digets“WWWWW”shows the value of weigh.
Example 2) Scan Form : [ 00XXXXX000000 ]
- From 3 to 5 digits “XXXXX” calls PLU by comparing with Mapping Code. At this time, you
must enter 5 digits as Mapping Code in menu1461.
Example 3) Scan Form : [ XXXXXXXXXXXXX ]
- The 13 digits bar code is calls PLU by comparing with Mapping Code. At this time, you must
enter 13 digits as Mapping Code at menu1461.
- It is possible to enter codes by using bar code scanner.
2.11.7 Label Format Key Table (Menu code 1470)
( MENU → 4. Store Data Table → 7. Label Format Key Table )
There is a function to change label format and Barcode by using function key. This menu is used to
set this function. You can use this function, after assigning empty key to that Function
Key(83-90).
1. Label Speed Key