163
2.15.5 X1/X2 PLU Report (Menu code 1612/1632)
( MENU → 6. Report → 1. X1 Report /3. X2 Report → 2. PLU Report )
Enter PLU range to check.
EX) dept 1, PLU 1 ~ 10
PLU sales report is shown on the display by
pressing “PRINT” key.
To print report, press “TEST” key.
* If your scale is in label mode, the scale shows “Do you want to print on label?”. * If your
label has gap, press 1. if you want to print report on ticket, press 0 and change the setting to
Ticket in menu 1731 then change your label to ticket
* “Do you want to print on label?” message is displayed depending on the setting of menu 1872
* Confirm Print Report on Label
* If you print report in label mode, rewind motor does not operated so you remove label and then
press the FEED key.
To exit this menu, press the “ESC” key.
Note: PLU with no sales is not printed.
To Next Page
Loading...
