CAS CL7200 series - Programming PLU Data Table I; Department Management

5
0
2.2.1.1 New/Edit Department (Menu code 1211)
( MENU → 2. PLU Data Table I → 1. Department → 1. New/Edit )
◆
You can press the SAVE key at anytime to save the current data and if
you want to exit without saving, press the ESC key.
1. Department Number
• Department number is available 1 to 99.
EX) Department No. = 2
2. Department Description
EX) Department Description = GROCERY
3. Speed Key Setting
• Refer to 2.6 Speed Key
EX) Speed key set no. = 1
Note: You can select from 5 different Speed Key sets. Refer to Section 2.6 Speed Key Set
No.
2.2.1.2 List Department (Menu code 1212)
( MENU → 2. PLU Data Table I → 1. Department → 2. List )
1. Enter the range of Departments
wish to see.
EX) Department 1 to 10
• If you want to print list, press the TEST key.
• Press Print Key to List Departments on screen. After Departments are listed on the screen
pressing the TEST key will print the Departments.