69
2.2.8.1 New/Edit Unit Symbol (Menu code 1281)
( MENU → 2. PLU Data Table I → 8. Unit Symbol → 1. New/Edit )
You can press the SAVE key at anytime to save the current data and if
you want to exit without saving, press the ESC key.
1. Enter unit number
• This value can be from 1 to 8.
EX) Qty Unit No. = 1
2. Enter unit symbol
EX) Symbol = ™
※
If you want to enter special symbol, press
the CHAR key and enter the code value.
(See ASCII code table on chapter 4.4)
3. Exit menu
• If you want to exit, press ESC key.
2.2.8.2 List Unit Symbol (Menu code 1282)
( MENU → 2. PLU Data Table I → 8. Unit Symbol → 2. List )
1. Set the list range
EX) Unit Symbols 1~8
• Press Print Key to List Unit Symbol No.’s on screen. After Unit Symbol No.’s
are listed on the screen, pressing the TEST key will print the Unit Symbol No.s.
To Next Page
Loading...
