Apex2
5
Safety and warnings
The Apex2 does not present a safety risk when you use it as instructed in this User Manual.
However, it is possible that the environment where you use the instrument may present a
safety risk. For this reason, always follow correct, safe working practices.
WARNING
Although the Apex2 is designed to be intrinsically safe (IS), you must comply with
these instructions relating to intrinsic safety:
Instructions specific to hazardous area installations (reference European ATEX
Directive (2014/34/EU, Annex II, 1.0.6.) and the following Intrinsic Safety
Standards:-
IEC60079-0:2011 IEC60079-11:2011
The following instructions apply to equipment covered by certificate number: CML
16ATEX2152, IECEx CML 16.0068, ANZEx 17.3007 (Australia and New Zealand) and
QPS (USA and Canada) LR1409-2 for the Apex2 series.
The following warnings should be observed for intrinsically safe versions of the
Apex2 Pump:-
• The Apex2 MUST be charged only using 1-Way Docking Station (Casella Part
Number 209152B), or 5-Way Docking Station (Casella Part Number
209156C). A Um of 63V is specified for the USB and DC power inputs of the
Docking station. This is ensured by connection to safety extra low-voltage
circuits (SELV) or protective extra low-voltage (PELV) circuits.
• DO NOT use the battery charger in a hazardous area.
• DO NOT attempt to download data via USB in a hazardous area.
• DO NOT use the equipment if the outer case of the instrument is cracked as
this invalidates the intrinsically safe certification.
• DO NOT service while in a hazardous area.
• The equipment is certified only for use in ambient temperatures in the
range -20
o
C to +45
o
C and MUST NOT be used outside this range.
• The user MUST ENSURE that the I.S. rating of the pump to be used is
suitable for the I.S. rating of the intended hazardous area.
To Next Page
Loading...
