Casio 5142 - To Manually Override a Time Calibration Standard Time;Daylight Saving Time Setting

E-53
To manually override a time calibration standard time/daylight saving time setting
Perform steps 1 and 2 under “To configure Home City 1.
settings” on page E-45.
Each time you select a city code, the •
z Hour Hand,
c Minute Hand, and v Mode Disk move to the
current time for that city code.
Hold down 2. A for about three seconds until the mode
pointer will point to DST.
This is the STD/DST manual/auto switching mode. •
Performing the above step selects manual DST •
switching.
Note that you cannot switch between manual and •
auto switching while the currently selected city code
of the Home City is one that does not support time
calibration signal reception.
Each press of 3. A toggles between STD and DST as
shown in the illustration to the left.
>
STD by manual setting
DST by manual setting