E-67
An ongoing stopwatch operation will continue even if you pull out the crown to •
perform some setting operation.
In the following cases, the hands of the watch are moving, so pressing • B will not
perform a reset operation.
While the hands are moving to elapsed timekeeping after you enter the Stopwatch −
Split Mode
While the watch is changing dates at midnight −
Once started, stopwatch timing continues until you press • A to stop it, even if you
exit the Stopwatch Split Mode to another mode and even if timing reaches the
stopwatch limit defined above.
You can press • A to start an elapsed time operation immediately after entering
the Stopwatch Split Mode, even if the watch’s hands are still moving to their initial
Stopwatch Split Mode positions. Note, however, that if the stopwatch was not
reset after the last elapsed time operation, timing will restart from where it was last
stopped, and not from 12 o’clock.
To Next Page
Loading...
