APPENDIX
256
1) Clean the lens.
2) Clean the phase differential sensor.
3) Move your finger so it does not block the phase
differential sensor.
4) Make sure the subject is centered in the focus
frame when composing the image.
5) Use manual focus (page 85).
6) Mount the camera on a tripod.
7) Change the Auto Focus mode setting to
“Contrast” (page 134).
When composing the image, make sure the
subject on which you want to focus is located
inside the focus frame.
1) Select a different flash mode (page 71).
2) Charge the battery (page 37).
3) Select a different REC mode.
4) Select a different flash mode (page 71) or
BESTSHOT scene (page 113).
1) The lens is dirty.
2) The phase differential sensor is dirty.
3) You are blocking the phase differential sensor
with your finger.
4) The subject is not located in the center of the
focus frame when you compose the image.
5) The subject you are shooting is a type that is
not compatible with Auto Focus operation (page
63).
6) You are moving the camera.
7) An Auto Focus mode other than “Contrast” is
selected while a conversion lens is installed on
the camera (page 134).
The image is not focused properly.
1)
(flash off) is selected as the flash mode.
2) The battery is dead.
3) The camera is in the Movie mode.
4) A scene that selects
(flash off) as the flash
mode is selected in the BESTSHOT mode.
Auto Focus does not focus
properly
The subject is out of focus
in the recorded image.
The flash does not fire.
Image Recording
Symptom Possible Cause Action
To Next Page
Loading...
Need help?
General
