VIEWING IMAGES ON A COMPUTER
193
IMPORTANT!
• Low battery power can cause the camera to power
down suddenly during data communication. Use of
the special AC adaptor is recommended to power the
camera during data communication.
• If you are using battery power without the AC
adaptor, make sure that the battery is fully charged.
• If you want to transfer files from the camera’s built-in
memory to a computer, make sure there is no
memory card loaded in the camera before you place
it onto the USB cradle.
Do not try to establish a connection between the
camera and computer before installing the USB
driver onto the computer. If you do, the computer will
not be able to recognize the camera.
• USB driver installation is required in the case of
Windows 98SE and 98. Do not connect the camera to
a computer running one of the above operating
systems without installing the USB driver first.
• USB driver installation is not required in the case of
Windows XP, 2000, and Me.
1.
What you should do first depends on whether
your computer is running under Windows XP,
2000, Me, 98SE, or 98.
Windows 98SE/98 Users
• Start from step 2 to install the USB driver.
• Note that the example installation presented here
uses Windows 98.
Windows XP/2000/Me Users
• Installation of the USB driver is not required, so jump
directly to step 6.
2.
Set the bundled CD-ROM into the CD-ROM
drive of your computer.
• Use the CD-ROM whose contents label shows “USB
driver”.
3.
On the menu screen that appears, click
“English”.
To Next Page
Loading...
Need help?
General
