11
E
Powering Up
Turning the printer on and off is as simple as pressing a button.
To turn power on and off
1.
Press the button to turn the printer on.
• This turns on power and displays a main menu screen like the one shown
below.
• The selection boundary indicates the icon that is currently selected on
the main menu.
2. To turn the printer off, press the button.
Auto Power Off
The printer automatically turns off if you do not perform any key operation for
about six minutes. To restore power, press
.
Initializing Printer Memory
You should initialize the memory of the printer before using it for the first time,
or if it fails to operate normally when you turn power on.
Important!
Initializing printer memory clears its memory of all input data.
To initialize printer memory
1. Make sure that the printer is turned off.
2. While holding down the PRINT and SPACE keys, press .
3. In response to the "INITIALIZE? SET/ESC" message that appears, press
SET to initialize printer memory and then display the display language
setting screen.
• To cancel initialization, press ESC instead of SET.
4. USE and to select the display language you want to use, and then
press SET.
This will display the length unit setting screen.
5. USE and to select centimeters (cm) or inches as the unit of
measurement, and than press SET.
• You can configure display language and length unit settings later, if you
want.
See "Configuring the Printer Setup" (page 46) for more information.
NEW icon
LAST DATA icon
Selection boundary
Currently selected function (icon)
STORED DATA icon
Shows the function of the
currently selected icon
To Next Page
Loading...
Need help?
General
Weight and Dimensions
