53
E
Error Messages
Message
See page:
Cause and Action
Message See page:Cause and Action
PRINTER NOT SHUT
DOWN PROPERLY
LAST TIME
INPUT A VALUE!
LABEL LONGER THAN
SETTING
SET/ESC
LENGTH OF PRINT IS
TOO LONG!
• The last time the printer was
used, the AC adaptor was
disconnected or the batteries
were removed while the
printer was turned on or
while PLEASE WAIT was
displayed, so the printer
could not power down
properly. Because of this,
some data in printer memory
became corrupted.
➜
Press any key to re-initialize
the data at the corrupted
location.
• You are trying to print
numbering labels without any
input.
➜
Input the numbers you want.
• To print, press SET.
• To cancel printing, press
ESC. You can then decrease
the number of characters,
change to a longer tape
setting, or select auto tape
length.
• You are trying to print
something that is longer than
the length of tape available.
➜
Make the label shorter or
reduce the number of copies.
10, 11, 47
24
30
17, 30
LOAD A TAPE
CARTRIDGE
LOW BATTERY!
LOW BATTERY!
CONTINUE TO
PRINT?
SET/ESC
• There is no tape cartridge
loaded in the printer or the
tape cartridge is not loaded
correctly.
➜
Check the tape cartridge.
• Battery power is low.
➜
Replace the batteries or use
the bundled AC adaptor to
power the printer.
• Temperature is below 10˚C
(50˚F)
➜
Move the printer to a location
where the temperature is
within the operating
temperature range (10˚C to
35˚C (50˚F to 95˚F)).
• Battery power is low.
➜
Replace the batteries or use
the bundled AC adaptor to
power the printer.
• Temperature is below 10˚C
(50˚F)
➜
Move the printer to a location
where the temperature is
within the operating
temperature range (10˚C to
35˚C (50˚F to 95˚F)).
13
47
47
To Next Page
Loading...
Need help?
General
Weight and Dimensions
