E
36
Part 4 - Inputting and Editing Label
Text
This section describes everything you need to know about deleting and
editing text you have already input.
Moving the Cursor
Use the cursor keys to move the cursor around the display and position it for
deleting and editing characters.
■ To move the cursor
Basic Alphanumeric Input
The following operation shows you the basic procedures for inputting letters
and numbers. Note that it assumes that a text input screen is already on the
display.
To input alphanumeric characters
Example: ABXYZ 1234567890
1. Input the characters by typing them on the printer’s keyboard.
• To input the uppercase letters, you can use either SHIFT or CAPS. With
SHIFT you must shift the keyboard for each character. With CAPS the
keyboard keeps its uppercase/ lowercase setting until you press CAPS
again.
• Press SPACE to input spaces.
• If you input a wrong character, press BS or DEL to delete it and input
again.
2. When you reach the end of a line of text, press SET.
To perform this operation:
Move the cursor left
Move the cursor right
Move the cursor up
Move the cursor down
Move the cursor to the beginning of
the current line of text
Move the cursor to the end of the
current line of text
Press this:
FUNCTION
FUNCTION
To Next Page
Loading...
Need help?
General
Weight and Dimensions
