Castolin Eutectic CastoTIG - Page 31

15
Downslope t
2
........................ 0.0 to 9.9 s, factory setting: 1 s
Important! The downslope t
2
is saved separately for the 2-step and 4-step opera-
ting modes.
Final current I
E
...................... 0 to 100 % of main current
Factory setting: 30 %
Electrode diameter ............... 0 to 4.0 mm (0.158 in.)
factory setting: 2.4 mm (0.095 in.)
Available parameters where the “Rod electrode (MMA) welding” mode (5) has been
selected:
Main current I
1
...................... CastoTIG 2201 DC: 10 to 180 A
(10) Welding current display ... for indicating the welding current for the parameters:
I
S
(starting current)
I
1
(main current)
Important! On welding torches with Up/Down functionality, the entire setting range
is available for selection while the machine is idling. During welding, the main
current can be corrected by +/-20 A.
I
2
(reduced current)
I
E
(final current)
Before the start of welding, the left-hand display shows the command value. For I
S
,
I
2
and I
E
, the right-hand display also shows the respective %-age of the main
current I
1
.
After the start of welding, the parameter I
1
is automatically selected. The left-hand
display shows the present actual value of the welding current.
The control panel indicates which position has been reached in the welding process
by means of a dimmed display of the parameters (I
S
, t
1
, ...).
CastoTIG 2201
DC control panel
(continued)