Castolin Eutectic CastoTIG - Selecting and Altering the Set-Up Parameter; Saving and Exiting; Available Set-Up Parameters; Level 1: Rod-Electrode Set-Up Parameters

44
- While pressing and holding the Set button (13), press the “Mode” button (1)
- The first set-up parameter is displayed (e.g. “HCU”)
Important! The first parameter to be displayed is always the one that was the last to be
selected the last time the set-up menu was accessed.
- Select the desired set-up parameter with the parameter selection buttons (8) and
(9).
- Alter the value of the set-up parameter with the adjusting dial (7)
- Press the Set button (13)
(1)
(5)
Selecting and
altering the set-
up parameter
Saving and
exiting
- Press the “Mode” button (1) to select the “Rod-electrode (MMA) welding” mode (5)
Level 1: Rod-electrode set-up parameters
Accessing
- Select the desired set-up parameter with the parameter selection buttons (8) and
(9).
- Alter the value of the set-up parameter with the adjusting dial (7)
Selecting and
altering the set-
up parameter
- Press the Set button (13)
ACF .... AC-frequency ... Syn / 40 to 250 Hz, factory setting: 60 Hz
2nd ..... Second level of the set-up menu (see “The set-up menu: Level 2”)
Saving and
exiting
Available set-up
parameters