56
Terms and abbreviations used
Arc ...... Arc-break watchdog
ASt ...... Anti-stick ... For reducing the effect of a “sticking” rod electrode (MMA welding)
C-C ..... Cooling unit control
dcY ..... Duty-cycle ... Ratio of pulse duration to background current duration (in TIG-AC
welding)
dYn ..... Dynamic ... Arc-force dynamic correction for rod electrode (MMA) welding
ELn ..... Electrode-line ... Characteristic selection (rod electrode [MMA] welding)
F-P ..... Frequency-Pulse ... Pulsing frequency
FAC .... Factory ... for resetting the welding machine
G-L ..... Gas post-flow time low ... Gas post-flow time at minimum welding amperage
G-H..... Gas post-flow time high ... Gas post-flow time at maximum welding amperage
GPr ..... Gas pre-flow time
HFt ..... High-frequency time ... High-frequency ignition
HCU ... Hot-start current ... (for rod electrode [MMA] welding)
Hti ....... Hot-current time ... (for rod electrode [MMA] welding)
I-E....... I (current) - End ... Final current
I-S....... I (current) - Starting ... Starting current
Ito ....... Ignition Time-Out
nEG .... Negative ... Negative half-wave (in TIG-AC welding)
Pos ..... Positive ... Positive half-wave (in TIG-AC welding)
SFS .... Special four-step
SPt ..... Spot-welding time
2nd ..... Second level of set-up menu
General remarks
Terms and abbre-
viations
The terms and abbreviations listed here are used in connection with functions that are
either included in the standard scope of supply or that are available as optional extras.
To Next Page
Loading...
