2
ENGLISH
EN
Introduction 3
Control panel 3
KEY AND KNOB COMMANDS 3
DISPLAY AND LED INDICATIONS 4
Switching on the welding machine and initial screen 4
Viewing the software version installed 4
Loading of the wire 5
Special functions “Fx” 5
SETUP Menu 6
FACTORY DEFAULT (FAC) 6
Menu SPECIAL FUNCTIONS 7
SAFETY CALIBRATION CODE (SCC) 7
MOTOR CALIBRATION (Mot CAL) 7
MIG-MAG synergic / MIG pulse / double pulsed MIG 8
1 - WELDING PROCESS SELECTION 8
2 - SELECTION OF WELDING PROGRAMME 9
3 - WELDING MODE SELECTION 9
4 - SPECIAL FUNCTIONS “Fx” SELECTION 9
5 - PRE-SETTING 10
6 - WELDING 10
7 - HOLD 11
MIG-MAG manual 11
1 - WELDING PROCESS SELECTION 11
2 - WELDING MODE SELECTION 11
3 - SPECIAL FUNCTIONS “Fx” SELECTION 12
4 - PRE-SETTING 12
5 - WELDING 13
6 - HOLD 13
Electrode (MMA) 14
1 - WELDING PROCESS SELECTION 14
2 - SELECTION OF WELDING PROGRAM 14
3 - SPECIAL FUNCTIONS “Fx” SELECTION 14
4 - PRE-SETTING 15
5 - WELDING 15
6 - HOLD 15
7 - ACTIVATING THE VRD DEVICE 16
TIG with “Lift” striking 16
1 - WELDING PROCESS SELECTION 16
2 - SPECIAL FUNCTIONS “Fx” SELECTION 16
3 - PRE-SETTING 17
4 - WELDING 17
5 - HOLD 17
JOB 18
1 - CREATING AND SAVING A JOB 18
2 - JOB SELECTION 18
3 - PRE-SETTING / VIEWING MEMORISED JOB
DATA 18
4 - WELDING 18
5 - HOLD 19
6 - MODIFICATION AND OVERWRITING OF A
MEMORISED JOB 19
7 - DELETING A JOB SAVED 19
Error condition 19
To Next Page
Loading...
