FI002K0018v1100UK – THS/21 Instruction manual for installation, use and maintenance
4
USE OF THE DEVICE
ORIGINAL INSTRUCTIONS 131
4.5.6 Removing and emptying the reject bin
The reject bin must be emptied at regular intervals.
During this operation exercise extreme caution. The reject bin could be heavy. You should define a procedure for this
operation. The manufacturer declines all liability for injury to persons or damage to property caused by emptying the bin
in an incorrect manner.
The bin has a maximum bearable load, shown on a label clearly placed on the bin itself. The
operator is responsible for emptying the bin periodically before this weight is exceeded.
Example of label
4.5.6.1 THS/FBB and THS/MBB
Press the Stop Belt button
Using the key provided, open the door
of the reject bin. Empty the bin.
Close the door again correctly.
Check that all the safety devices are
present and efficient. Check for other
hazards. Start the belt by pressing the
Start button.
4.5.6.2 THS/FB and THS/M69K
Press the Stop Belt button
Using
the key provided, release the reject
bin. Turn the handle to release it.
Remove the bin from its seat.
Empty the bin.
At the end of the operation, place the
bin in the guides and lock it again, with
the handle or the safety key.
After emptying, slide the bin
onto its guides. Lock it in
position with the handle and
the key.
Check that all the safety devices are
present and efficient. Check for other
hazards. Start the belt by pressing
the Start button.
To Next Page
Loading...
