13
System Installation
System Installation
Unboxing
1. View the Site Preparation Guide (P/N FM0050) and select a location that meets requirements before installing
the MARS 6 iWave instrument.
2. Carefully inspect the shipping carton, the instrument, and accessories for any damage that may have occurred
during shipping. If the instrument or accessories have damage, contact the freight carrier to report the damage
and le a damage report. Contact your CEM Representative for assistance.
WARNING
If any damage to the instrument is noted, do not attempt instrument operation.
3. Pull plastic tab, swing handle open, and remove the plastic assembly from box. Repeat process on the remain-
ing handles.
4. Use top handles to pull up and remove outer box.
5. Carefully cut the tape on both sides of the inner box.
To Next Page
Loading...
