25
3. Select “Name” to name the method being created. The keypad will appear on the screen.
4. Using the keypad, select the name of the method being created. Note: To toggle between upper and lower case
letters for the method name, select the “shift” key on the keypad. To toggle to numbers and symbols for the
method name, select “alt” on the bottom of the keypad. To use a subscript, select the “sub” key. Use the
backspace “del” (delete) key to delete unwanted letters and/or numbers. Use the space bar to enter a space in
the method name. Once the name is properly selected and displayed, select “Hide” to close the keypad.
5. Touch “Select Control Type” to select the desired control type for the method (Ramp to Temperature, Ramp to
Pressure, Standard, Power Time, or Evaporation).
6. Select and highlight the desired control type.
7. Select “OK.”
To Next Page
Loading...
