CEM MARS 6 - Page 77

72
123. Select “Temperature.”
Note: The temperature increments are 1, 5 or 10. If the temperature parameter increment is set for 1, when programming
a method, the temperature can be chosen in 1 degree increments. If the temperature parameter increment is set for 5 or
10, the temperature can be selected in 5 or 10 degree increments, etc.
124. Select the appropriate temperature parameter increment (1, 5 or 10).
125. Select “OK.”
126. Select “Power.”
Note: The power increments are 10, 25, 50 or 100. If thepower parameter increment is set for 10, when programming a
method, the temperature can be chosen in 10 degree increments. If the power parameter increment is set for 25, 50 or
100, the temperature can be selected in 25, 50 or 100 degree increments, etc.
127. Select the appropriate temperature parameter increment (10, 25, 50 or 100).