24
- QuikPrep Temperature: displays the actual
temperature and set temperature of the QuikPrep
heater at the top of the magnet. The icon will display
a red bar/up arrow when warming up, and a blue
bar/down arrow when cooling down. The QuikPrep
heater will take approximately2 minutes to heat
10°C, and 10 minutes to cool 10°C
- The Barcode Scanner, which displays the number of
tests the current roll of Trac Film has left. The icon
will display a yellow icon when there are 100 tests
remaining, and a red icon when there are 20, as a
reminder to purchase more film before it runs out.
The user can scan in or manually enter a new
barcode by pressing the Barcode icon, then the
Scanner button.
- This screen also allows the user to personalize the
reminders, or use a One-Time Pass in the instance a
barcode was lost or thrown away before being
scanned.
Note: The One-Time Pass can only be used once, and will
not be available after it is used. If an issue occurs where
a bar code is lost after having already used the One-Time
Pass, please contact the Process Control Group at CEM
Corporation
- The balance icon indicates if the CEM supplied
balance is connected and communicating with the
ORACLE software. The balance is only for customers
not using a SMART 6 for moisture content.
-
The SMART 6 icon indicates if the SMART 6 is
connected and communicating with the ORACLE
software. This is only for customers using the SMART
6 for rapid moisture analysis.
To Next Page
Loading...
Need help?
General
