70
System
The “System” settings are used to record and control
ORACLE information and connections, along with basic user
interface controls.
Magnet S/N – This logs the serial number for the
ORACLE magnet should for record keeping.
Processor S/N - This is where the serial number for
the ORACLE Processor box should be logged for
record keeping.
System Time – This is used to set the correct time for
the ORACLE so it is accurately reflected in sample
logs.
Volume – This adjusts the volume of the speakers
for videos and other auditory cues on the ORACLE.
SMART 6 – This setting must be turned “ON” in
order for the ORACLE to connect with a SMART 6
moisture/solids analyzer. Note- this setting should
be “OFF” for high throughput users without a
SMART 6.
Automation: Use Robot – Setting this “ON” will allow
the ORACLE to connect with the High Throughput
Robot option.
Simulate Instruments – Turning this on will allow
users to mimic the ORACLE performance without
actually running any samples, and is primarily used
as a sales and demonstration tool.
Service Mode – This will allow CEM trained
specialists to have additional access to certain
system parameters and functions as necessary for
servicing or optimizing the ORACLE.
Screen Saver – This can be used to adjust the time in
minutes until the ORACLE screensaver is activated
since the last time the touchscreen was touched.
‘Recent Results’ age filter – This will change the
number of results that appear in the ‘Recent Results’
page.
To Next Page
Loading...
Need help?
General
