CEMB SM628TI - Page 40

40 User’s manual
WARNING
Thisoperatingphasemayinvolvenoiselevelsof85dB(A).
Itisthereforesuggestedthatearprotectorsbeworn.
Itissuggestedtoweareyeprotectiontopreventinjurydueto
contactwithdustsoranyfragmentsinsertedintothetyre.
DANGER
Aburstingtyrecancauseprojectionsofitspartsinsurroundingareaswitha
forcesufcienttocauseseriousinjuryordeath.
Donotmountatyreifitsdimensions(indicatedontheside)donotcorrespond
exactlytotherimdimensions(printedinsidetherim)oriftherimorthetyreis
defectiveordamaged.
Neverexceedthepressurerecommendedbythetyremanufacturer.
Thetyrechangerisnotasafetydeviceanddoesnotpreventtyresandrimsfrom
exploding.Keepallpersonsnotworkingonthemachineoutoftheworkingarea.
9.7.b.TYREINFLATION
-Make sure the wheel is NOT
clamped on the turntable by the
centring jaws (Fig. 28).
- Move the horizontal arm to the
wheel centre (all slipped off towards
the operator)
- Lower the vertical arm until it
touches the rim (g.29), then clamp
the arm in this position.
- Remove the valve core if it has not already been
removed (Fig. 30).
- Connect the Doyfe connector of the inating hose
to the valve stem (Fig. 31).
- Inate the tyre with the appropriate gun or by
pressing the pedal in an intermediate position (Fig.
34). Frequently check the pressure on the pressure
gauge to make sure that the pressure NEVER
exceeds the maximum pressure indicated by the
manufacturer on the tyre.
NO
YES
28
29