EasyManua.ls Logo

CENNTRO LOGISTAR 400 - Page 112

Default Icon
206 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Operation
101
Operation
An improperly attached, damaged, folded, or stacked floor mat, or damaged
floor mat fasteners may cause your floor mat to interfere with the accelerator,
brake,or clutch pedals and cause a loss of vehicle control. To prevent SERIOUS
INJURY or DEATH:
ALWAYS securely attach your floor mat using the floor mat fasteners. DO NOT
install your floor mat upside down or turn your floor mat over. Lightly pull to
confirm mat is secured using the floor mat fasteners on a regular basis.
ALWAYS removed the existing floor mat from the vehicle before installing any
other floor mat. NEVER install or stack an additional floor mat on top of an
existing floor mat.
ONLY install floor mats designed to fit your vehicle. NEVER install a floor mat
that cannot be properly attached and secured to your vehicle. If a floor mat
needs to be replaced, only use a manufacture approved floor mat for the
specific make, model and year of your vehicle.
ONLY use the drivers side floor mat on the drivers side floor area. To check
for interference, with the vehicle properly parked, fully depress the
accelerator and brake pedals to check for interference. If your floor mat
interferes with the operation of any pedal, or is not secure to the floor,
remove the floor mat from the vehicle and place the floor mat in your trunk.
ALWAYS make sure objects cannot fall or slide into the driver’s side floor area
when the vehicle is moving. Objects can become trapped under accelerator
or brake pedals and could cause a loss of vehicle control.
NEVER place any objects under the floor mat (e.g., towels, keys, etc.). These
objects could change the position of the floor mat and may cause
interference with the accelerator or brake pedals.
If the vehicle carpet has been removed and re-installed, always properly
attach carpet to the floor and check the floor mat fasteners are secure to the
vehicle carpet. Fully depress each pedal to check for interference with the
accelerator or brake pedals then re-install the floor mats.
It is recommended to only use mild soap and water to clean your floor mats.
After cleaning, always check your floor mat has been properly installed and
is secured to your vehicle using the floor mat fasteners by lightly pulling mat.

Table of Contents

Related product manuals