Check whether the exterior rearview mirror and interior rearview mirror lenses are
complete and whether the mirror surface is clean.
For manual rearview mirror, check whether the mirror angle can obtain ideal
vision. If not, adjust the mirror surface to obtain ideal vision. If the lamp cover and
rearview mirror are damaged or fallen off, please drive the vehicle to the CENNTRO
authorized service center for replacement or repair.
Driver Sun Visor
Check whether the sun visor is fixed firmly and whether the cord rebound
mechanism operates well.
• In the process of driving, if the sun visor suddenly falls off, it may cause the
driver's poor vision or nervous mood and cause accidents.
Equipment Completeness
Please check whether the vehicle equipment such as common tools and spare
equipment are complete and intact, and whether the vehicle auxiliary facilities are
in normal use, so as to avoid unnecessary loss or safety damage.
Inspection and Operation After Vehicle Startup
Inspection and Operation at Vehicle Startup
1. Turn the ignition switch to the "ON" position, and check whether the alarm
indicator lamps are normally lit, and whether the barometer display meets the
starting conditions (6 bar (0.6 MPa)).
2. Confirm that the gear panel is in the neutral position, and then turn to the START
position to enter the driving Ready state.
3. Press the brake pedal to determine the vehicle's static state, select gear, then
release the brake pedal, press the accelerator pedal, and the vehicle will drive.
ABS Function Check
Turn on the low-voltage main switch, turn the ignition key to the ON position, and
the ABS system performs a self-test. The ABS indicator lamp on the instrument
lights up for 4s and then goes out.
To Next Page
Loading...
