• Try to use taxiing deceleration. During vehicle deceleration, try to use taxiing
deceleration to facilitate the recovery of electric energy. For non-emergency
braking under normal conditions, you only need to release the accelerator pedal
and gently press the brake pedal to facilitate the slow braking function of the
motor (note: it cannot be released at one step like the traditional air brake).
• In case of emergency braking, the driver must step on the brake pedal as quickly
as the conventional vehicle to ensure the safety of pedestrians and vehicles.
• Pay attention to the use of air conditioning. Before turning on the air conditioner
in summer, you should first open the window to let out the hot air; when driving,
the window should be closed strictly, the air conditioner should be set at 77 ℉
(25 ℃ ), and the air exchange function should be used when the temperature is
not very high.
• Control the tire pressure. If the tire pressure is 20% lower than normal, the
power consumption will increase by about 8%; when the air pressure is high,
the consumption is low, but the tire life is shorter and the adhesion is reduced.
Therefore, it is necessary to select the tire and tire pressure correctly.
• Tips for energy saving in driving operation:
» The starting throttle must be small, and stepping slowly is the most reliable;
» The accelerator and brake are well controlled at crosswalks and curves;
» Slow down and release the accelerator in advance when stopping at a red
light;
» Get rid of bad habits such as frequent acceleration and sudden braking;
» Pay attention to the use of air conditioner and do not use it when the vehicle is
not in operation;
» Let's compete with each other. You can be the champion of energy
conservation.
Check and Adjust the Vehicle Before Starting
To ensure driving safety, check or adjust the following items before starting the
vehicle:
• Tire pressure
• Adjustment of steering wheel and driving position
To Next Page
Loading...
