Defroster Function Check
Before driving in autumn and winter, check whether the defroster operates
normally, whether the defroster vent is open, and whether the defroster vent angle
is adjusted to the best position. Operate the defroster switch on the instrument
panel in two gears. Low gear, low wind speed, natural wind defrosting; high gear,
high wind speed, electric heating defrosting.
Lighting Signal Inspection
Check the working reliability of all lighting signal equipment, such as the headlamp
(front turn signal, front position lamp, high beam lamp, low beam lamp), rear tail
lamp (turn signal, brake lamp, rear position lamp, reverse lamp), front fog lamp,
rear fog lamp, etc., for normal operation and damage.
If you find that the lamp works abnormally, please repair it in a timely manner. If
you can't eliminate the fault, please consult the CENNTRO authorized service center.
Starting and Driving
Starting Operation
After the preparation before driving, the vehicle can be started to avoid large
throttle. During driving, select the gear reasonably according to the road conditions.
Auxiliary Power Start
When the battery is power off and the whole vehicle cannot be powered on,
auxiliary power can be used to start the vehicle. Connection procedure:
1. Turn off the motor of the vehicle with a good battery.
2. Connect one end of the booster cable (red) to the positive terminal of the
power-off battery and the other end to the positive terminal of the live battery.
Connect one end of the other booster cable (black) to the negative terminal of a
good battery, and the other end to the chassis frame of a vehicle equipped with
a power-off battery, which must be as far away from the battery as possible.
3. After connecting the booster cable, start the motor of the vehicle with no
battery. If the temperature is too low to start, run the motor of the normal vehicle
for several minutes before starting the motor of the vehicle with no battery.
4. After the motor is started, remove the cable according to the reverse procedure
of the wiring procedure.
To Next Page
Loading...
