Hazard Switch
To activate the hazard indicators, push the Hazard Switch which is located on
the left side of the steering wheel area on the dash. The exterior indicator lights
will flash continuously. To deactivate the hazard indicators, push the Hazard
Switch again.
.
• With extended use, the hazard warning indicators may wear down your
batteries.
• Turn signals do not work when the hazard warning flasher lights are on.
Triangle Warning Board and On-board Tools
Use and Placement of Triangle Warning Board
When the vehicle needs to stop in an emergency due to fault or other special
reasons, it is necessary to take out the triangle warning board.
The triangle warning board shall be
placed in the following way: on the
general road, the triangle warning
board shall be placed at 160~330 ft
(50~100 m) in the direction of the
coming vehicle, and on the highway,
it shall be placed at 500 ft (150 m)
away from the direction of the coming
vehicle, and the reflective surface shall
face the direction of the coming vehicle.
If this placement requirement conflicts
with the traffic regulations, the traffic
regulations shall prevail.
On-board Tools
On-board tools are directly provided to the user when the user picks up the vehicle.
The following points should be noted during use:
· The jack provided at the time of delivery can only be used for this model
according to regulations. Before the jack is put back in its fixed position, please
fully retract the jack arm. Otherwise, there is a risk of injury.
· If you have to work under the vehicle, you must use suitable cushion blocks to
firmly support the vehicle, otherwise there is a risk of injury.
To Next Page
Loading...
