3. Unscrew the water filling cap of the
water tank and add coolant until the
coolant fills the water tank and flows
out of the overflow gap.
· The antifreeze is toxic and must not be swallowed.
· Do not open the water filling cover of the auxiliary water tank when the
motor is hot, otherwise there is a risk of scalding.
· Collect the discharged coolant in a container and dispose it according to the
regulations of environmental protection.
· Please select a coolant whose freezing point is lower than the minimum
temperature in the vehicle operation area.
Tire Pressure Monitoring System
The tire pressure monitoring system is used to monitor the tire pressure and
temperature in real time. LOGISTAR 400 adopts six-wheel CAN instrument tire
pressure monitoring system. It consists of six transmitters, one repeater, one CAN
receiver, six straps, etc.
The transmitter is fixed on the wheel hub with a strap. The transmitter can monitor
the tire pressure and temperature and send the data wirelessly. The CAN receiver is
responsible for receiving the data sent by the front wheel transmitter and uploading
the information to the CAN network. When the tire pressure and temperature are
abnormal, it will send a warning to the CAN network and display and alarm through
the instrument. The repeater is installed on the rear beam, receives the data sent by
the rear wheel transmitter, and transmits the data to the instrument display through
the harness to realize real-time monitoring of tire pressure and temperature.
To Next Page
Loading...
