• Driving mode:
» Only those who have received relevant training can carry out the traction work,
especially when using the traction rope. Both drivers should be familiar with
the special requirements of the traction process, and untrained drivers should
not conduct traction starting and traction.
» Always pay attention when towing and adjust your driving mode to ensure that
there is no excessive tension and impact load. The danger of overload may
occur when driving with traction force outside the hard road.
• Please comply with relevant laws and regulations.
• The flashing alarm devices of the tractor and the towed vehicle shall be
turned on.
• Remove the fused fuse. If the vehicle cannot be towed in the normal way, it
must be transported away on a special transport vehicle or trailer.
Replace Fuse and Lamp
Replace the Fuse
The electrical box of this vehicle is located under the right instrument panel. Before
replacing the damaged fuse, turn off the corresponding electrical power switch.
The replacement steps are as follows:
1. Remove the fused fuse.
» Remove the fuse box cover.
» Find out the model of the blo-
wn fuse according to the fuse
c o n f i g u r a t i o n t a b l e o n t h e
electrical box.
» Pull out the fused fuse.
To Next Page
Loading...
