SOLOY TURBINE PAC SECTION 4
POHS CESSNA T206H/206H NORMAL PROCEDURES
4-4
F.A.A. Approved November 17, 2015
CHECKLIST PROCEDURES
PREFLIGHT INSPECTION
1. CABIN
1. Pitot Tube cover -- REMOVE. Check for pitot blockage.
2. Pilot's Operating Handbook and Soloy POH Supplement --
AVAILABLE IN THE AIRPLANE.
3. Airplane Weight and Balance – CHECKED.
4. Parking Brake – SET.
5. Control Wheel Lock – REMOVE.
6. Avionics Master Switch - OFF
7. Battery Switch – ON.
8. Fuel Quantity Indicators – CHECK QUANTITY and ENSURE
LOW FUEL ANNUNCIATORS (L LOW FUEL R) ARE
EXTINGUSHED.
9. Avionics Master Switch – ON
10. Avionics Cooling Fan – CHECK AUDIBLY FOR OPERATION
11. Avionics Master Switch – OFF
12. Static Pressure Alternate Source Valve – OFF
13. Annunciator Panels Test Switches – ACTIVATE TEST
SWITCHES AND ASSURE ALL ANNUNCIATORS ILLUMINATE
NOTE
When Battery Switch is turned ON, some
annunciators will flash for approximately
10 seconds before illuminating steadily.
14. Fuel Selector Valve – BOTH
15. Wing Flaps – EXTEND
16. Pitot Heat – ON. (Carefully check that pitot tube is warm to the
touch within 30 seconds.)
17. Pitot Heat - OFF
18. Battery Switch – OFF.
19. Trim Controls – Neutral
20. Oxygen Supply Pressure – CHECK (If installed)
21. Oxygen Masks – CHECK (If Installed)
To Next Page
Loading...
